Menu
What's new
By:
Filters Better Search

Search results

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. T

    Pfsense/opnsense box with AX88U Merlin firmware

    Don't know. - I only have the 1 AP - AX88u with multiple VLANs. Here's the guide that I used to configure it. Just note that if you're using the WAN port as trunk, - you won't be able to ssh or access the config page from WAN port once configured. You'll have to be on the main wifi or one of...
  2. T

    Pfsense/opnsense box with AX88U Merlin firmware

    There are some guides on how to configure the AX88U with multiple VLANs - can do up to 7 VLANs on Wifi, or perhaps 8. I'm currently running 6 VLANs with the AX88U set up as an AP. Opnsense / pfsense are excellent - and will require a fair bit of time of tinkering. Initial configuration may...
  3. T

    Fun with ChatGPT...

    This just made my friday morning - thank you, 😂😂😂
  4. T

    RT-AX88U_3004_388.7_0

    So far so good since doing the hard-reset on the 388.700. All is working fine. I have the following configuration and (point that I need to remember) Unit is configured as an AP only - with the trunk cable going to the WAN port. I have 5 - VLANs coming in on the WAN port (eth0), and then...
  5. T

    RT-AX88U_3004_388.7_0

    Version 3004_388.6_2 is stable for me. At the moment though, I have upgraded to 3004_388.7_0 and did the hardware factory reset, then reconfigured everything from scratch. Will see how it goes. If it crashes in a couple of days, I'll just downgrade again, and wait for another update.
  6. T

    RT-AX88U_3004_388.7_0

    I had done a soft factory reset from within when I had installed it initially. But after reading a number of the comments on the other thread that it's working fine - with a reset. I've just upgraded it again back to 3004_388.7_0, and did a method 2 hard factory reset, and redid the...
  7. T

    RT-AX88U_3004_388.7_0

    Just downgraded to the previous firmware. Similar problems, - the wifi suddenly drops, or there's no traffic for a bit, - cannot ping the router, etc....- would have to turn off / turn on the router for it to work again....- the previous version was stable.
  8. T

    QNAP 4.4.1.1216, - hacked? Seeking opinions.

    The issue was not a hack. It was the Qsirch and another utility by Qnap. As Qnap upgraded the OS, it introduced "better" search functionality, with AI - so that you can find what you're looking for faster with better results, - images and documents. So, when those services are enabled (cunningly...
  9. T

    Traffic analyzer - dig deeper

    aaah - thanks.
  10. T

    QNAP 4.4.1.1216, - hacked? Seeking opinions.

    @dosborne - many thanks. I thought more about what you'd said, and I think that you're right. After installing the most recent update, I hadn't logged into the system till the incident. In the messages that I was prompted - one had to do with data - privacy, and I recall agreeing to it. (i was...
  11. T

    Traffic analyzer - dig deeper

    @Val D. It's an Asus RT-AX88U...thanks
  12. T

    QNAP 4.4.1.1216, - hacked? Seeking opinions.

    @ColinTaylor , - perhaps - although I doubt - as I usually receive a push notification that a firmeware update is available - ready for installation; but that wasn't the case then. May be it was something carried over from the last update. @dosborne - that's comforting to know. @L&LD - thanks...
  13. T

    Traffic analyzer - dig deeper

    where are those tools? would they tell me the internal IP address of the traffic and perhaps the port? - I'm still learning about Merlin. - The downloaded traffic is Steam, I was setting up a gaming computer at the time, but didn't enable any outgoing streams from Steam. Many thanks Val
  14. T

    QNAP 4.4.1.1216, - hacked? Seeking opinions.

    Hmmm, I'm going to be hopeful and run with perhaps no-one had gotten in - i just don't know. Perhaps, some fault or so in the QNAP OS that produced those messages of drives formatted and privacy. The QNAP mycloud service had always 2FA enabled since I signed up to it, and I've disabled it now...
  15. T

    QNAP 4.4.1.1216, - hacked? Seeking opinions.

    Router ought to be secure. Running Merlin's 384.15 - with skynet installed - with custom and large ip-filters - and with diversion and dnsproxy. I don't have any IoT devices. All remote access & management into the network is disabled (no vpn or anything allowed inwards). The only service...
  16. T

    Traffic analyzer - dig deeper

    Hi, I've scavenged around but perhaps not deep enough, so seeking some help. Is it possible for me to review - pull out any logs from the traffic monitor page (within the traffic analyzer tab), to identify IP-related traffic. When I look at the daily graph - it is reporting that I had...
  17. T

    QNAP 4.4.1.1216, - hacked? Seeking opinions.

    Hi, I noticed something bizarre late yesterday when I logged onto my TVS NAS, that has me confused. Perhaps, someone can give an opinion on this. Please excuse the long narrative. - I logged on via the web-browser, and was prompted with a message asking me to agree on Data-Privacy for Qnap, -...
    • tigo13
    • Thread
    • Replies: 12
    • Forum: QNAP
Top