AX3000 Firmware Update

[davekstl]

I have a AX3000 attached to my AiMesh system. I am being notified that there is a new Firmware Update. Version 3.0.0.4.384_9890. But when I go to the Asus site, this version is not listed. https://www.asus.com/Networking/RT-AX3000/HelpDesk_BIOS/ Is there another way to update this firmware? I typically download the file this do a manual update.
The other possibility is the there is an issue with the Ali-Mesh App.
Any advice and opinions would be appreciated.
Dave

 

[OzarkEdge]

I have a AX3000 attached to my AiMesh system. I am being notified that there is a new Firmware Update. Version 3.0.0.4.384_9890. But when I go to the Asus site, this version is not listed. https://www.asus.com/Networking/RT-AX3000/HelpDesk_BIOS/ Is there another way to update this firmware? I typically download the file this do a manual update.
The other possibility is the there is an issue with the Ali-Mesh App.
Any advice and opinions would be appreciated.
Dave

It takes awhile to populate everywhere.

I found it close by:

OE

 

[davekstl]

Can you send the url?

I get this:

 

[OzarkEdge]

Can you send the url?

I get this:

View attachment 27024

The URL doesn't really get you there. Look under Driver & Tools\Other OS as was shown.

OE

 

[davekstl]

Thanks...check...done...

 

[davekstl]

The URL doesn't really get you there. Look under Driver & Tools\Other OS as was shown.

OE

Thanks...check...done...

 

[ultrakiasu]

I have a AX3000 attached to my AiMesh system. I am being notified that there is a new Firmware Update. Version 3.0.0.4.384_9890. But when I go to the Asus site, this version is not listed. https://www.asus.com/Networking/RT-AX3000/HelpDesk_BIOS/ Is there another way to update this firmware? I typically download the file this do a manual update.
The other possibility is the there is an issue with the Ali-Mesh App.
Any advice and opinions would be appreciated.
Dave

Need to highlight about the bugs appeared on this above mentioned new firmware.

Bugs after updating from the previous release.
Wireless Password containing "&" symbols will be displayed ok on "Wireless" page, but garbed in the "Network Map" Status page.
Originally thought was browser issue, but tested on both Chrome and Edge, displayed incorrect password, replacing "&" with extra characters.

Running TUF-AX3000 as primary router (AiMesh), and RT-AC88U as node. Ethernet Backhaul. Smart Connect.