With the introduction of the bandwidth monitor and traffic analyzer I am going to try and finally retire per IP monitoring so I can fire up NAT acceleration. My question is, I realize per ip traffic is incompatible with NAT but is global traffic accuracy affected? The global monthly traffic numbers are important to me as I need to monitor bandwidth usage against the Comcast cap which will eventually be coming.
Global Traffic Stats with NAT
- Thread starter cmillar6
- Start date
Global traffic is unreliable with CTF enabled. Asus recently added a warning to the Traffic Monitor page to warn users about it.
CTF does a lot of low-level tricks and sometimes even dirty hacks to increase throughput.
Similar threads
Similar threads
Similar threads
-
DNS Director (Global redirection = router, User defined 1 = pihole) not sending anything to user defined 1
- Started by palo857
- Replies: 11
-
Have global ipv6 address but unable to access internet over ipv6
- Started by klunk
- Replies: 45
-
-
Forward only specific port's traffic to Wireguard VPN
- Started by NetNewb124
- Replies: 1
-
How to NAT traffic inbound to a specific host or network ?
- Started by mekabe remain
- Replies: 6
-
-
Using VPN Director to route only torrent traffic through VPN
- Started by goldnet
- Replies: 9
-
Asus RT-AX58U v2 Merlin: Route all traffic to Pi-hole (running directly on router itself)
- Started by hamensman
- Replies: 12
-
How can I monitor all Ip traffic from my wyze camera in Merlin?
- Started by lenovomen
- Replies: 2
-