Issue with vpn client after a line disconnect

[nova]

I'm running the latest Marlin cfw on my 3200 router and I had to pull the phone line, after reconnecting it my VPN client is no longer blocking my IP and doing what it should but in the settings all looks well and has been untouched. Ive tried rebooting the router but this hadn't fixed the issue, I can access the Internet fully but just with no VPN? Surely I don't have to reimport the config for my VPN company every time the lone drops?

If anyone has any ideas I'd be greatful because I can't use the VPN service with the router!

 

[nova]

had to reload the VPN services config file again and it fixed the issue, going to get annoying lol.

 

[L&LD]

Do you have the VPN enabled to 'start with WAN'?

You shouldn't need to reload the config file each time otherwise, just start the VPN client after a reboot (this is by design).

 

[nova]

Do you have the VPN enabled to 'start with WAN'?

You shouldn't need to reload the config file each time otherwise, just start the VPN client after a reboot (this is by design).

It said it was already running but not doing what it should? Never mind, its working now.

 

[L&LD]

It said it was already running but not doing what it should? Never mind, its working now.

I have seen it say the same when it was obviously not connected. Either you need to be patient (and it will connect automatically after a few minutes), or, stop and start the client to connect immediately.