RT-AC68U port forwarding issues

[viper2059]

I have been having issues of my port forwards not staying after hitting apply but if i enter them in a second time they will show on the list. If i close my router config after this and go back the ones i just entered no longer show. I had this issue first with build 376.45 and now updated to 376.48_1 and still have the same issue. I did not do a reset to default when updating to 376.48_1 but i did when i first installed 376.45. I also have NAT acceleration disabled.

Edit: I just checked the system logs for port forwards and shows the two i set up but they do not show in the port forwarding tab in the WAN section. Is this just a GUI glitch and should be fine?

 

[viper2059]

My port forwards are now gone once again and not just from the port forwarding tab but from system log as well. Is this a known issue with Merlin builds?

 

[knighthawk]

If it's just a gui glitch then you should probably see them in vts_rulelist

nvram show |grep vts_rulelist

I don't know if it's a known issue or not, I'm on a ac68 with 374.43 fork and haven't had them disappear on me, in the gui or otherwise yet.

 

[viper2059]

Should I downgrade to a older build then? I've only used 376.45 and the new one.