RT-AC88U sees all USB3 disks as USB 2

[Wulfie]

I just purchased this router, before i return it, i was wondering if anyone had same issue. I am running Merlin firmware 384.9, and any and all USB disk/pen etc show up as USB 2. I read in other forums something in the 2.4 wireless settings to disable usb inteference. I cannot find that in the professional section. If anyone can advise me, I was thinking of loading up the stock firmware to see if it resolves. Rgds.

Wulfie

 

[L&LD]

Please do not crosspost. See my answer in the other thread you started.

 

[Wulfie]

Here's the log, i see no superspeed, maybe thats it???

Feb 22 23:04:32 kernel: xhci_hcd 0000:00:0c.0: xHCI Host Controller
Feb 22 23:04:32 kernel: xhci_hcd 0000:00:0c.0: new USB bus registered, assigned bus number 1
Feb 22 23:04:32 kernel: xhci_hcd 0000:00:0c.0: irq 112, io mem 0x18023000
Feb 22 23:04:32 kernel: xhci_hcd 0000:00:0c.0: Failed to enable MSI-X
Feb 22 23:04:32 kernel: xhci_hcd 0000:00:0c.0: failed to allocate MSI entry
Feb 22 23:04:32 kernel: usb usb1: No SuperSpeed endpoint companion for config 1 interface 0 altsetting 0 ep 129: using minimum values
Feb 22 23:04:33 kernel: hub 1-0:1.0: USB hub found
Feb 22 23:04:33 kernel: hub 1-0:1.0: 1 port detected
Feb 22 23:04:33 kernel: [xhci-hub] usb2mode:[0]
Feb 22 23:04:33 kernel: ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
Feb 22 23:04:33 kernel: ehci_hcd 0000:00:0b.1: EHCI Host Controller
Feb 22 23:04:33 kernel: ehci_hcd 0000:00:0b.1: new USB bus registered, assigned bus number 2
Feb 22 23:04:33 kernel: ehci_hcd 0000:00:0b.1: irq 111, io mem 0x18021000
Feb 22 23:04:33 kernel: ehci_hcd 0000:00:0b.1: USB 0.0 started, EHCI 1.00
Feb 22 23:04:33 kernel: hub 2-0:1.0: USB hub found
Feb 22 23:04:33 kernel: hub 2-0:1.0: 2 ports detected
Feb 22 23:04:33 kernel: ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
Feb 22 23:04:33 kernel: ohci_hcd 0000:00:0b.0: OHCI Host Controller
Feb 22 23:04:33 kernel: ohci_hcd 0000:00:0b.0: new USB bus registered, assigned bus number 3
Feb 22 23:04:33 kernel: ohci_hcd 0000:00:0b.0: irq 111, io mem 0x18022000
Feb 22 23:04:33 kernel: hub 3-0:1.0: USB hub found
Feb 22 23:04:33 kernel: hub 3-0:1.0: 2 ports detected
Feb 22 23:04:33 kernel: SCSI subsystem initialized
Feb 22 23:04:33 kernel: Initializing USB Mass Storage driver...
Feb 22 23:04:33 kernel: usbcore: registered new interface driver usb-storage
Feb 22 23:04:33 kernel: USB Mass Storage support registered.
Feb 22 23:04:33 kernel: Tuxera FAT 12/16/32 driver version 3015.1.29.5 [Flags: R/W MODULE].
Feb 22 23:04:33 kernel: Built against headers 2.6.36.4brcmarm #3 SMP PREEMPT Mon Sep 3 18:00:49 CST 2018 arm
Feb 22 23:04:33 kernel: Running on kernel 2.6.36.4brcmarm #1 SMP PREEMPT Sat Feb 2 13:28:19 EST 2019 armv7l
Feb 22 23:04:34 kernel: Tuxera NTFS driver 3018.6.22d [Flags: R/W MODULE].
Feb 22 23:04:34 kernel: Built against headers 2.6.36.4brcmarm #3 SMP PREEMPT Mon Sep 3 18:00:49 CST 2018 arm
Feb 22 23:04:34 kernel: Running on kernel 2.6.36.4brcmarm #1 SMP PREEMPT Sat Feb 2 13:28:19 EST 2019 armv7l
Feb 22 23:04:34 kernel: Tuxera HFS+ driver 3017.6.20
Feb 22 23:04:34 kernel: Built against headers 2.6.36.4brcmarm #3 SMP PREEMPT Mon Sep 3 18:00:49 CST 2018 arm
Feb 22 23:04:34 kernel: Running on kernel 2.6.36.4brcmarm #1 SMP PREEMPT Sat Feb 2 13:28:19 EST 2019 armv7l
Feb 22 23:04:34 kernel: usbcore: registered new interface driver usblp
Feb 22 23:04:34 kernel: usb 2-2: new high speed USB device using ehci_hcd and address 2
Feb 22 23:04:34 kernel: scsi0 : usb-storage 2-2:1.0

 

[Wulfie]

apologies, i will remove it and post this there