Slow WAN with VPN Director turned on

[Sp0X]

Hi all.
Tell me, please, what rules should be set in the VPN director so that the speed over the WAN does not drop to the speed of the VPN connection.
I only use it to access some ip from all devices. Maybe it's because I'm using wireguard? I read the entire forum, but I did not find such information.

Internet speed measured by iperf and speedtest is 2 times slower than when VPN Director is turned off. For me, this is critical, but I also want to leave VPN access.

 

[RMerlin]

The issue is caused by Wireguard, not by VPN Director.

Wireguard forces NAT acceleration to be disabled due to incompatibility between the two technologies.

388.2 will use a new feature implemented by Broadcom/Asus which will allow non-WG traffic to still benefit from NAT acceleration, except on the RT-AX88U and GT-AX11000 which at this time isn't supported by this new feature.

 

[Tech9]

except on the RT-AX88U and GT-AX11000

GT-AXE11000 good? It's the same hardware as GT-AX11000, no?

 

[RMerlin]

GT-AXE11000 good? It's the same hardware as GT-AX11000, no?

GT-AXE11000 is a different SDK version than the two others.

 

[Sp0X]

The issue is caused by Wireguard, not by VPN Director.

Wireguard forces NAT acceleration to be disabled due to incompatibility between the two technologies.

388.2 will use a new feature implemented by Broadcom/Asus which will allow non-WG traffic to still benefit from NAT acceleration, except on the RT-AX88U and GT-AX11000 which at this time isn't supported by this new feature.

Can you tell me when to wait for the release of 388.2?

 

[RMerlin]

Can you tell me when to wait for the release of 388.2?

I don't have any ETA, sorry. It depends in part on Asus creating the missing models GPL.