Menu
What's new
By:
Filters Better Search

dual wan

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. V

    Dual WAN Gateway Access

    I’m using Dual WAN configuration on an Asus router. The router gateway is 192.168.50.1 while gateway of router that serves secondary WAN is 192.168.8.1 Can I access my secondary WAN router (192.168.8.1) through my main router (192.168.50.1)? Thanks for reading.
  2. L

    Reboot issue on AX88U 3.0.0.4.386_41700

    I faced a reboot issue on AX88U 3.0.0.4.386_41700. Every time I applied some settings in the AX88U, it needs a reboot. However, all WAN connections are shown as disconnected after the reboot. I need to manually reboot all modems after my AX88U rebooted. Unplugging the cable does not help This...
  3. F

    How to ping/telnet to the secondary WAN box?

    I'm using an XT8 in dual WAN mode with failover. From my LAN, I can easily ping or telnet to the modem on my primary WAN. How can I do the same to reach the modem on my secondary WAN, while it's in standby. I haven't tried it yet, but I suspect I won't be able to reach my primary WAN when I'm...
  4. B

    AC86U: Dual WAN Routing Rules - Trying to set *only* one device to use secondary WAN

    I'm just trying to configure the dual wan options, not for load balancing or failover, I just one device to use the secondary wan interface. Everything else I'd like route thru the primary wan interface. All devices are on the same subnet. Now, I can get my one device to reliably route thru...
  5. T

    Solved Stuck at 100 MBPS On GT-AC2900 WAN Port

    Hey everyone, Wanted to make a post here since I had a few good leads here but none solved my issue. The issue: WAN port stuck at 100 mbps on my Asus GT-AC2900 (with actual speeds only reaching 10mbps max on the 10/100) Things I tried to fix it: Disabling QoS, multiple CAT 5E cable...
  6. F

    Draytek 2925N Dual WAN conflict

    I have EE's DSL router [smart hub firmware 0.05.02.04290-ee] which I want to plug into my Draytek 2925N dual wan cable router. WAN1 has an existing working internet connection. I assume the Draytek WAN option I should use is "Static or Dynamic IP" and it asks for the following...
  7. A

    Make VPN router connect through wan1 on dual wan

    Hello everyone, I have seen many cases in this forums speaking about this case in particular, I have tried many things but I couldn't get through it, I will tell you what I've done step by step and if you can help me achieve it I would appreciate it, I activated my dual wan in Load Balance...
  8. T

    Dual Wan-1 ISP, 2 Lan lines into Wan & Wan/Lan

    Does this setup actually help? I'm running one gig fiber line into modem. Then two Lan lines into an rt-ac88u one Wan and the other Lan as the dedicated dual wan port. I did some custom routing and other testing, things seem quicker, but I'm not sure if there's any actual real world load...
  9. Kashif Tasneem

    Dual WAN Load Balance or Fallback?

    Hi guys. I have 2 internet connections. Primary Internet connection is 50 Mbps while secondary is 20 Mbps. I am confused whether to enable load balance or fallback in Dual Wan. I would love to enable Load balance but it disables AI Protection, QoS, Traffic Analyzer and Bandwidth Monitor. My main...
  10. P

    I'm giving up with Asus

    I've been looking for months for a mesh system I could install in my quite big house. My goal is to set one main router, 2 satellites wired to the router via an ethernet backhaul, and 1 satellite linked over wifi to another unit. I also want my connection to switch to 4G when main wan fails...
  11. screamjojo

    [RT-AX56U] Problem DUAL WAN with Huawei E587

    Hello, I connected a 3G modem Huawei E587 to the USB 2.0 port of my Asus router, I configured the APN parameters and it seems OK because when I unplug the WAN cable I have internet traffic (capture below) during few seconds then goes to Cold-Standby, then reconnects for a few seconds and it...
  12. S

    Dual WAN device to run OpenVPN and QoS

    I hope you are all staying safe out there. I need some advice. Currently the office has a 45/15Mbit connection and a Celeron based QNAP running OpenVPN configured as split-tunnel and this just isn't enough to support 10+ staff working from home. There are about 6 RDP (Home PC>OpenVPN>Office PC)...
  13. Kashif Tasneem

    GT AX-11000 Traffic Analyzer for Secondary WAN?

    Hi. I have setup dual WAN as fail over on my AX-11000 router. For last 4 days, my primary WAN is down and secondary WAN is up. Today I noticed that traffic analyzer is not being populated. Is this normal that data is not populated from secondary WAN? Can I do anything to fix it?
  14. Kashif Tasneem

    Dynamic DNS for Secondary WAN?

    Hi. I have setup Dual WAN as failover and I am using Asus DDNS on my router. When my Primary WAN is up, I can easily connect to my router remotely through the DDNS. But when Primary WAN is down and Secondary WAN is up, DDNS does not work. Shouldn't it automatically update the IP? Is there...
  15. E

    RT-AC2900 / RT-AC86UC DUAL Network for VPN

    hey, i'm not good at scripts and still trying to understand them. I want two wireless networks on my router (RT-AC2900). one with VPN and one regular (local IPS). can you help me convey this wish to the developers of merlin so that they incorporate a nice feature that does not require script...
  16. S

    3G/4G Dongle connected but no internet

    Hi, I moved into a new house a couple of days ago and set up broadband early so we'd have internet access quickly. I've been told there's a 'construction issue' so there will be a delay. I need constant internet access for my 3D rendering program and access to my router for the NAS. The best...
  17. J

    Please help - Asus RT-AC86U with failover dual WAN OpenVPN and port forwarding breaks

    Hi all, My apologies up front if my question or terminology is out of wack as I am a bit of a noob when it comes to this sort of stuff. Anyway I was hoping @RMerlin or someone could help with the following problem: I am running dual wan for the purpose of failover and failback as my HFC...
    • Justifier1
    • Thread
    • dual wan failback failover hfc lb2120 openvpn port forwarding rt-ac86u
    • Replies: 2
    • Forum: VPN
  18. H

    Dual WAN load-balance brakes VPN on AC5300 w/ 384.10_2

    Hello all, I had my AC5300 running 384.10_2, with one WAN connection, two VPN connections, and some clients strictly locked into using the VPNs with "Block routed clients if tunnel goes down" working flawlessly, prior to today. Today a second WAN connection was installed and I enabled "Dual...
  19. sshanky

    RT-AC68U dual WAN showing "cold-standby" and didn't fail over

    I thought I set up my dual wan properly, but last night when the primary WAN went down, the router didn't fail over. On checking, I noticed it was reporting "cold-standby": https://www.dropbox.com/s/0h7casz1co1ic38/Screenshot 2018-12-27 10.15.54.png?dl=0 Here are the dual-wan settings...
  20. A

    RT-AC88U & 4G-AC53U // dual WAN // VPN

    Summary: I'd like to access my LAN/the resources in my LAN via a VPN-connection with a mobile broadband connection. Network properties: RT-AC88U router with local IP 10.100.200.1 connected to a high speed network with private WAN IP 192.168.1.x and capability for dual WAN, 4G-AC53U mobile...
Top