384.7_2 bug UPNP setting & AI Protection disagree

[eastavin]

Since installing this update from 384.7 I have noticed that AI protection reports 1 risk - it says UPNP disabled NO.

When I goto the WAN screen and check the enable UPNP setting it says NO.

I disabled and renabled AI Protection and scanned and the report is still the same. I also reapplied the wan screen with the UPNP setting NO.

No difference. Any suggestions on how to verify if the UPNP is on or off? Should I roll back to 384.7?

 

[skeal]

Since installing this update from 384.7 I have noticed that AI protection reports 1 risk - it says UPNP disabled NO.

When I goto the WAN screen and check the enable UPNP setting it says NO.

I disabled and renabled AI Protection and scanned and the report is still the same. I also reapplied the wan screen with the UPNP setting NO.

No difference. Any suggestions on how to verify if the UPNP is on or off? Should I roll back to 384.7?

Reset to factory defaults and set the router back up manually, meaning no importing of saved configs, use screenshots.

 

[eastavin]

Reset to factory defaults and set the router back up manually, meaning no importing of saved configs, use screenshots.

Ok I will give that a go.

I noticed that before doing the manual setup you recomend the port forwarding log shows two PCs I recognize with ports forwarded so I gather that the update from .7 to .7_2 must have something in it that is defeating the "no UPNP" setting. This setting has been OFF/NO for over a year.

Rebooting turns off the forwarded ports but in a few hours the forwards are back on again.

I will now go a try the manual reset.

 

[eastavin]

Reset to factory defaults and set the router back up manually, meaning no importing of saved configs, use screenshots.

Did a factory "restore". Seems to have fixed it. Thanks.

 

[eastavin]

Oops. spoke too soon. Seems the AI Protection is failing to assess the UPNP status properly. Keeps reporting that it is enabled when it is NOT. So that must be a bug.

At least the ports forward log shows NO ports forwarded at this time and the UPNP setting on the WAN screen is NO. Asus RT-AC68U C1

 

[RMerlin]

It probably checks the second WAN interface status, which can be separately enabled.