Hi guys,
I have an AC66U and my ISP gave me a FTTH modem where there is no possibility of converting it to bridge, so I have to use it as DMZ to have access from the internet.
Using the Asus "official firmware" ipv6 works normally using passthrough mode, but with Merlin does not happen in the same way. As soon as I activate the passthrough option the stations receive ipv6 addresses normally, but the router starts to loop (restarting) and only stops when I completelly disable ipv6
I also tried to set ipv6 to "Native" option but the devices connected to the router do not receive a v6 address as they should. I´m currently using the "380.65_2" version but have already tested previous versions and had the same problem.
Has anyone ever experienced this? Any tip or another test that I can do?
Best regards from Brazil and sorry for the bad english
Tks!
Eduardo.
I have an AC66U and my ISP gave me a FTTH modem where there is no possibility of converting it to bridge, so I have to use it as DMZ to have access from the internet.
Using the Asus "official firmware" ipv6 works normally using passthrough mode, but with Merlin does not happen in the same way. As soon as I activate the passthrough option the stations receive ipv6 addresses normally, but the router starts to loop (restarting) and only stops when I completelly disable ipv6
I also tried to set ipv6 to "Native" option but the devices connected to the router do not receive a v6 address as they should. I´m currently using the "380.65_2" version but have already tested previous versions and had the same problem.
Has anyone ever experienced this? Any tip or another test that I can do?
Best regards from Brazil and sorry for the bad english
Tks!
Eduardo.
Last edited: