Asus RT-AC87U&WRT Merlin 378.54_2&6 TB RAID1 device problem

[arag0rn]

Hey, tonight got a problem with fresh system. Sorry me noob in *nix systems.
ext4 drive with 2x6 tb wd6efrx drives in raid1 mirror.

After router reboot usb drive gone from system.

Jan  1 03:00:39 kernel: Initializing USB Mass Storage driver...
Jan  1 03:00:39 kernel: usbcore: registered new interface driver usb-storage
Jan  1 03:00:39 kernel: USB Mass Storage support registered.
Jan  1 03:00:40 kernel: Tuxera FAT 12/16/32 driver version 3014.7.30 [Flags: R/W MODULE].
Jan  1 03:00:40 kernel: Tuxera NTFS driver 3014.7.29 [Flags: R/W MODULE].
Jan  1 03:00:40 kernel: Tuxera HFS+ driver 3014.7.28
Jan  1 03:00:40 kernel: xhci_hcd 0000:00:0c.0: xHCI Host Controller
Jan  1 03:00:40 kernel: xhci_hcd 0000:00:0c.0: new USB bus registered, assigned bus number 1
Jan  1 03:00:40 kernel: xhci_hcd 0000:00:0c.0: irq 112, io mem 0x18023000
Jan  1 03:00:40 kernel: xhci_hcd 0000:00:0c.0: Failed to enable MSI-X
Jan  1 03:00:40 kernel: xhci_hcd 0000:00:0c.0: failed to allocate MSI entry
Jan  1 03:00:40 kernel: usb usb1: No SuperSpeed endpoint companion for config 1  interface 0 altsetting 0 ep 129: using minimum values
Jan  1 03:00:40 kernel: hub 1-0:1.0: USB hub found
Jan  1 03:00:40 kernel: hub 1-0:1.0: 1 port detected
Jan  1 03:00:40 kernel: [xhci-hub] usb2mode:[0]
Jan  1 03:00:40 kernel: ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
Jan  1 03:00:40 kernel: ehci_hcd 0000:00:0b.1: EHCI Host Controller
Jan  1 03:00:40 kernel: ehci_hcd 0000:00:0b.1: new USB bus registered, assigned bus number 2
Jan  1 03:00:40 kernel: ehci_hcd 0000:00:0b.1: irq 111, io mem 0x18021000
Jan  1 03:00:40 kernel: ehci_hcd 0000:00:0b.1: USB 0.0 started, EHCI 1.00
Jan  1 03:00:40 kernel: hub 2-0:1.0: USB hub found
Jan  1 03:00:40 kernel: hub 2-0:1.0: 2 ports detected
Jan  1 03:00:40 kernel: ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
Jan  1 03:00:40 kernel: ohci_hcd 0000:00:0b.0: OHCI Host Controller
Jan  1 03:00:40 kernel: ohci_hcd 0000:00:0b.0: new USB bus registered, assigned bus number 3
Jan  1 03:00:40 kernel: ohci_hcd 0000:00:0b.0: irq 111, io mem 0x18022000
Jan  1 03:00:40 kernel: hub 3-0:1.0: USB hub found
Jan  1 03:00:40 kernel: hub 3-0:1.0: 2 ports detected
Jan  1 03:00:40 kernel: usbcore: registered new interface driver usblp
Jan  1 03:00:41 kernel: usbcore: registered new interface driver asix
Jan  1 03:00:41 kernel: usbcore: registered new interface driver cdc_ether
Jan  1 03:00:41 kernel: usbcore: registered new interface driver rndis_host
Jan  1 03:00:41 kernel: cdc_ncm: 14-Mar-2012
Jan  1 03:00:41 kernel: usbcore: registered new interface driver cdc_ncm
Jan  1 03:00:41 kernel: usbcore: registered new interface driver cdc_wdm
Jan  1 03:00:41 kernel: usb 1-1: new SuperSpeed USB device using xhci_hcd and address 2
Jan  1 03:00:41 kernel: usbcore: registered new interface driver qmi_wwan
Jan  1 03:00:41 kernel: xhci_hcd 0000:00:0c.0: WARN: short transfer on control ep
Jan  1 03:00:41 kernel: xhci_hcd 0000:00:0c.0: WARN: short transfer on control ep
Jan  1 03:00:41 kernel: xhci_hcd 0000:00:0c.0: WARN: short transfer on control ep
Jan  1 03:00:41 kernel: xhci_hcd 0000:00:0c.0: WARN: short transfer on control ep
Jan  1 03:00:41 kernel: xhci_hcd 0000:00:0c.0: disable burst on ep 1
Jan  1 03:00:41 kernel: xhci_hcd 0000:00:0c.0: WARN no SS endpoint bMaxBurst
Jan  1 03:00:41 kernel: cdc_mbim: loaded
Jan  1 03:00:41 kernel: usbcore: registered new interface driver cdc_mbim
Jan  1 03:00:41 kernel: xhci_hcd 0000:00:0c.0: disable burst on ep 2
Jan  1 03:00:41 kernel: xhci_hcd 0000:00:0c.0: WARN no SS endpoint bMaxBurst
Jan  1 03:00:41 kernel: scsi0 : usb-storage 1-1:1.0
Jan  1 03:00:41 start_nat_rules: apply the nat_rules(/tmp/nat_rules_ppp0_eth0)!
Jan  1 03:00:42 kernel: scsi 0:0:0:0: Direct-Access     JMicron  RAID-1           0100 PQ: 0 ANSI: 5
Jan  1 03:00:42 kernel: sd 0:0:0:0: Attached scsi generic sg0 type 0
Jan  1 03:00:42 kernel: sd 0:0:0:0: [sda] Very big device. Trying to use READ CAPACITY(16).
Jan  1 03:00:42 kernel: sd 0:0:0:0: [sda] 11721045152 512-byte logical blocks: (6.00 TB/5.45 TiB)
Jan  1 03:00:42 kernel: xhci_hcd 0000:00:0c.0: WARN: Stalled endpoint
Jan  1 03:00:42 kernel: sd 0:0:0:0: [sda] Write Protect is off
Jan  1 03:00:42 kernel: sd 0:0:0:0: [sda] Assuming drive cache: write through
Jan  1 03:00:42 kernel: sd 0:0:0:0: [sda] Very big device. Trying to use READ CAPACITY(16).
Jan  1 03:00:42 kernel: xhci_hcd 0000:00:0c.0: WARN: Stalled endpoint
Jan  1 03:00:42 kernel: sd 0:0:0:0: [sda] Assuming drive cache: write through
Jan  1 03:00:42 kernel:  sda: unknown partition table
Jan  1 03:00:42 kernel: sd 0:0:0:0: [sda] Very big device. Trying to use READ CAPACITY(16).
Jan  1 03:00:42 kernel: xhci_hcd 0000:00:0c.0: WARN: Stalled endpoint
Jan  1 03:00:42 kernel: sd 0:0:0:0: [sda] Assuming drive cache: write through
Jan  1 03:00:42 kernel: sd 0:0:0:0: [sda] Attached SCSI disk
Jan  1 03:00:42 rc_service: asus_sd 735:notify_rc restart_xhcimode 2

After physical cable replug it's ok

Jun 15 02:51:30 kernel: usb 2-1: new high speed USB device using ehci_hcd and address 2
Jun 15 02:51:31 kernel: scsi1 : usb-storage 2-1:1.0
Jun 15 02:51:32 kernel: scsi 1:0:0:0: Direct-Access     JMicron  RAID-1           0100 PQ: 0 ANSI: 5
Jun 15 02:51:32 kernel: sd 1:0:0:0: Attached scsi generic sg0 type 0
Jun 15 02:51:32 kernel: sd 1:0:0:0: [sda] Very big device. Trying to use READ CAPACITY(16).
Jun 15 02:51:32 kernel: sd 1:0:0:0: [sda] 11721045152 512-byte logical blocks: (6.00 TB/5.45 TiB)
Jun 15 02:51:32 kernel: sd 1:0:0:0: [sda] Write Protect is off
Jun 15 02:51:32 kernel: sd 1:0:0:0: [sda] Assuming drive cache: write through
Jun 15 02:51:32 kernel: sd 1:0:0:0: [sda] Very big device. Trying to use READ CAPACITY(16).
Jun 15 02:51:32 kernel: sd 1:0:0:0: [sda] Assuming drive cache: write through
Jun 15 02:51:32 kernel:  sda: unknown partition table
Jun 15 02:51:32 kernel: sd 1:0:0:0: [sda] Very big device. Trying to use READ CAPACITY(16).
Jun 15 02:51:32 kernel: sd 1:0:0:0: [sda] Assuming drive cache: write through
Jun 15 02:51:32 kernel: sd 1:0:0:0: [sda] Attached SCSI disk
Jun 15 02:51:33 hotplug[1503]: USB ext4 fs at /dev/sda mounted on /tmp/mnt/HDD
Jun 15 02:51:33 usb: USB ext4 fs at /dev/sda mounted on /tmp/mnt/HDD.
Jun 15 02:51:33 kernel: EXT4-fs (sda): mounted filesystem with ordered data mode. Opts: user_xattr
Jun 15 02:51:34 admin:  sh /opt/S95transmission.1 start

How to fix it or make a script to automate rescan of usb drive?

 

[freddy fish]

Same here: on initial boot, the USB3 disk is not handled. When pluggin in the device after boot completed - no issues.
Any updates?

Aug 1 02:00:27 kernel: xhci_hcd 0000:00:0c.0: Failed to enable MSI-X
Aug 1 02:00:27 kernel: xhci_hcd 0000:00:0c.0: failed to allocate MSI entry
Aug 1 02:00:27 kernel: usb usb1: No SuperSpeed endpoint companion for config 1 interface 0 altsetting 0 ep 129: using minimum values
Aug 1 02:00:27 kernel: usb 1-1: Device not responding to set address.
Aug 1 02:00:28 kernel: usb 1-1: Device not responding to set address.
Aug 1 02:00:28 kernel: usb 1-1: device not accepting address 0, error -71
Aug 1 02:00:28 kernel: usb 1-1: Device not responding to set address.
Aug 1 02:00:28 kernel: usb 1-1: Device not responding to set address.
Aug 1 02:00:28 kernel: usb 1-1: device not accepting address 0, error -71
Aug 1 02:00:28 kernel: usb 1-1: Device not responding to set address.
Aug 1 02:00:29 kernel: usb 1-1: Device not responding to set address.
Aug 1 02:00:29 kernel: usb 1-1: device not accepting address 0, error -71
Aug 1 02:00:29 kernel: usb 1-1: Device not responding to set address.
Aug 1 02:00:29 kernel: usb 1-1: Device not responding to set address.
Aug 1 02:00:29 kernel: usb 1-1: device not accepting address 0, error -71
Aug 1 02:00:29 kernel: hub 1-0:1.0: unable to enumerate USB device on port 1