jasons6930
Regular Contributor
Hi Guys,
Running the above AP and would like to make use of Eth1.
As far as i was aware, ETH1 could be used as another ethernet port, to plug in another switch or individual client.
Problem is, when i plug anything in, it makes the WAP inaccessible, and does not forward an IP address to the connected client. Unplugging and all seems to work fine.
I have had a look through the WAP settings etc, but can't see anything relevant.
Any pointers appreciated!
Running the above AP and would like to make use of Eth1.
As far as i was aware, ETH1 could be used as another ethernet port, to plug in another switch or individual client.
Problem is, when i plug anything in, it makes the WAP inaccessible, and does not forward an IP address to the connected client. Unplugging and all seems to work fine.
I have had a look through the WAP settings etc, but can't see anything relevant.
Any pointers appreciated!