Entware dig can not run in 386.12

[ColinTaylor]

Is this relatively clean to do? I am still chasing my favorite problem, and may try this. Here is the problem I have:

Scribe - /usr/bin/logger messages don't make it to the log file - intermittent issue

I am running Scribe with Entware. Sometimes my cron job messages don't make it to the "messages" file for stretches of time, then it's all fine again for a while. Here is an example of a cron job that I want to output to messages every 15 min: cru a temp "*/15 * * * * /jffs/scripts/temp_check...

www.snbforums.com

After holidays I'll probably go to 12_4 version, and re-do Entware packages here. Don't want family to lose holiday internet, LOL

It's fairly harmless, unless you have a hardware issue with your USB drive. I doubt that it will have any effect on your problem though.

 

[northumberland]

I had the same problem with the aarch64-k3.10 version of bind-dig. In my case it was just returning a Bus error message.

In the end I had to force remove and reinstall a lot of libraries to get it to work:

opkg --force-depends remove libgcc libpthread libc libssp librt libopenssl zlib libatomic libuv libnghttp2

opkg install libgcc libpthread libc libssp librt libopenssl zlib libatomic libuv libnghttp2

opkg --force-depends remove libgcc libpthread libc libssp librt libopenssl zlib libatomic libuv libnghttp2
opkg --force-depends install libgcc libpthread libc libssp librt libopenssl zlib libatomic libuv libnghttp2

Worked for me on Fresh Tomato where I had the same problem, thanks!

 

[martinr]

opkg --force-depends remove libgcc libpthread libc libssp librt libopenssl zlib libatomic libuv libnghttp2
opkg --force-depends install libgcc libpthread libc libssp librt libopenssl zlib libatomic libuv libnghttp2

Worked for me on Fresh Tomato where I had the same problem, thanks!

Worked for me, too, on Merlin 386.12 running on RT-AC68U.. And now passes the dig functionality test in RTMON. @ColinTaylor thanks, too.