Skynet Dual-WAN support?

[vertigo888]

Hi - Does Skynet support Dual-WAN? I have a Dual WAN setup. If it doesn't, are there plans to support it and with firewall enabled within the Merlin firmware, will the WAN thats's not covered by Skynet be protected?

 

[dave14305]

It does not support Dual WAN. Is it a failover or load-balanced configuration?

 

[vertigo888]

It's in a load balanced configuration but I have specific clients going down each WAN via rules.

Just to double check here - I have the firmware firewall enabled anyway. This will cover both WAN even with skynet enabled for only 1 of them?

 

[JT Strickland]

It's in a load balanced configuration but I have specific clients going down each WAN via rules.

Just to double check here - I have the firmware firewall enabled anyway. This will cover both WAN even with skynet enabled for only 1 of them?

I have Dual WAN setup due to WAN port failure, with primary WAN set to a LAN port. Router shows secondary as cable unplugged.
Skynet works for me.

 

[JuanGF]

Is this still true?

I have Dual Wan in Load Balance and Skynet logs only seems to be aware of ppp0 (Primary WAN)

 

[dave14305]

Is this still true?

I have Dual Wan in Load Balance and Skynet logs only seems to be aware of ppp0 (Primary WAN)

Yes, Skynet only checks wan0_ifname. Just curious what interface(s) are being passed to firewall-start in your system log in LB mode?

grep "firewall-start" /jffs/syslog.log-1 /jffs/syslog.log

 

[JuanGF]

I don't get anything with that command.

 

[JuanGF]

It seems my logs are in /tmp/ and not in /jffs/ . This is the output:

/tmp/syslog.log:May  8 02:49:56 custom_script: Running /jffs/scripts/firewall-start (args: ppp0)