Mathieu
Regular Contributor
Hello
Thanks to RMerlin for the new release, the benefits of which need not be lauded further.
But, as is always the case for me, with each new release come new challenges, and this time it's got to do with IPTV. Oh well...
It's been a few releases now since ISP specific settings were made available under the LAN/IPTV tab.
At first I'd try those using the 'M o v i s t a r Triple WAN' option. (My Internet and TV Service Provider -blank spaces are mine).
That didn't work. But the fallback manual settings option had been working well, for at least as far as the 384 releases - here under 386.2_2:
Now, my trouble w/ 386.3_2 is that those previous manual settings no longer work after upgrade.
I gave another shot at the ISP specific settings (which require informing specific IPs and DNS).
I managed to get it work, sort of, as load time is much longer and some channels (paid for sports etc) just didn't show.
I am back to my last working setup, but angrily feel I am so close to both a better solution, and an up-to-date firmware...
My TV decoder has always been plugged into LAN 4 port of the router, and by pulling up the syslog right after boot, I could see that under 386.3_2
there were entries for br1: port 5 eth4.501 and br2: port 5 eth4.502
Whereas under the old firmware (and working config) only could I see entries for port 5 eth4.502 with no reference to br2: port 5 eth4.501
Hopefully the screenshots may be helpful to the knowledgeable. In any case, if someone could point me in the right direction, I should be most grateful.
Thanks
Thanks to RMerlin for the new release, the benefits of which need not be lauded further.
But, as is always the case for me, with each new release come new challenges, and this time it's got to do with IPTV. Oh well...
It's been a few releases now since ISP specific settings were made available under the LAN/IPTV tab.
At first I'd try those using the 'M o v i s t a r Triple WAN' option. (My Internet and TV Service Provider -blank spaces are mine).
That didn't work. But the fallback manual settings option had been working well, for at least as far as the 384 releases - here under 386.2_2:
Now, my trouble w/ 386.3_2 is that those previous manual settings no longer work after upgrade.
I gave another shot at the ISP specific settings (which require informing specific IPs and DNS).
I managed to get it work, sort of, as load time is much longer and some channels (paid for sports etc) just didn't show.
I am back to my last working setup, but angrily feel I am so close to both a better solution, and an up-to-date firmware...
My TV decoder has always been plugged into LAN 4 port of the router, and by pulling up the syslog right after boot, I could see that under 386.3_2
there were entries for br1: port 5 eth4.501 and br2: port 5 eth4.502
Whereas under the old firmware (and working config) only could I see entries for port 5 eth4.502 with no reference to br2: port 5 eth4.501
Hopefully the screenshots may be helpful to the knowledgeable. In any case, if someone could point me in the right direction, I should be most grateful.
Thanks