RT-AC3100 Link Aggregation/LACP in AP Mode

[Wingsfan87]

Is this possible? In Router mode you have the option under Lan > Switch Control. However soon as I switch it to AP mode this disappears as a GUI option. If yes, what is the command line in can run via SSH to enable it in AP mode?

Devices:
Gateway/Main Router - AC5300 ver 380.65.2
AP - AC3100 380.65.2
Switch - Cisco SG200-26 running LACP on 2 x 2 ports

Setup:
Main Router is using the LACP/Link Agg option to run to switch on ports 1 and 2. Switch is configured to have those 2 ports for teaming with LACP. Checked status on switch and and it shows LACP is active with both ports. AP is on ports 3 and 4 of the switch and running to ports 1 and 2 on the AP. Before I turned on AP mode I turned on LACP mode in the router mode. After turning on AP mode I check the switch management page and the first router is still working great with LACP active on ports 1 and 2. But ports 3 and 4 show only 1 active and 1 passive so LACP isn't enabled anymore on AP I am guessing. How would I check this via SSH command line for status and how would I turn it on?

 

[Wingsfan87]

Just wanted to see if anyone has any ideas?

 

[Yuri Sevatz]

Just came back with an answer because this is one of the top google results for AC3100 Link Aggregation --

This works:
1. Switch back to Router mode.
2. Go to LAN -> Switch Control.
3. (... Change any Switch Control Options you want...)
4. Switch back to AP mode.

This may work in AP mode:
1. Login to your router
2. Go to the page http://<router_ip>/Advanced_SwitchCtrl_Content.asp
3. (... Change any switch Control Options you want...)

Seems Asus may have a bug in their firmware where these tabs aren't exposed?