Hey! I restored to the router factory defaults, additionally, I went back to 384.19 firmware, then I had to restore factory defaults again, because of the password wasn't working for the admin account. Something is still going on, on my iPhone I can't make the Wireguard VPN to work. The phone connects to the VPN, but the internet is dropping frequently. So at this point I'm out of my plans.The vlan 56-62 entries make no sense. They’re bridging LAN directly to WAN in like 3 places.
factory reset time. Do not restore a backup.
This is what I get back when I ssh to the router.
@RT-AC68U-3E28:/tmp/home/root# robocfg show
Switch: enabled
Port 0: 1000FD enabled stp: none vlan: 2 jumbo: off mac:
Port 1: 1000FD enabled stp: none vlan: 1 jumbo: off mac:
Port 2: DOWN enabled stp: none vlan: 1 jumbo: off mac: 00:00:00:00:00:00
Port 3: DOWN enabled stp: none vlan: 1 jumbo: off mac: 00:00:00:00:00:00
Port 4: DOWN enabled stp: none vlan: 1 jumbo: off mac: 00:00:00:00:00:00
Port 5: 1000FD enabled stp: none vlan: 1 jumbo: off mac:
Port 7: DOWN enabled stp: none vlan: 1 jumbo: off mac: 00:00:00:00:00:00
Port 8: 1000FD enabled stp: none vlan: 1 jumbo: off mac:
VLANs: BCM5301x enabled mac_check mac_hash
1: vlan1: 1 2 3 4 8t
2: vlan2: 0 8t
56: vlan56: 0 5 7 8t
57: vlan57: 0t 1t 3 4t 7t 8u
58: vlan58: 0 4t 5t 7t 8u
59: vlan59: 1t 4t 8u
60: vlan60: 0 1t 2t 3t 5t 8t
61: vlan61: 0 1t 2t 4 7
62: vlan62: 0 1 3 5t
@RT-AC68U-3E28:/tmp/home/root# brctl show
bridge name bridge id STP enabled interfaces
br0 8000.40167e583e28 yes vlan1
eth1
eth2