I am using Firmware:374.43_2 (Merlin build) on the RT-AC68U.
The router is connected via DMZ to a Huawei 4G router.
I am unable to use any DDNS services as the asus router is detecting the WAN IP: 192.168.1.254.
When i used to use dd-wrt, if i remember correctly, there was a stp button on the basic config page. If this was checked, it would ignore the lan ip and manage to locate the wan ip.
Does anyone know if this is possible using the merlin firmware.
At present, i cannot use the ddns service.
Thank you.
Correction to the above, it is not the stp button. It is the below.
On my previous dd-wrt router which was also connected to the huawei router, i also received the ip address of 192.168.1.254 until i checked the radio button "do not use external ip check" on the ddns page.
The router is connected via DMZ to a Huawei 4G router.
I am unable to use any DDNS services as the asus router is detecting the WAN IP: 192.168.1.254.
When i used to use dd-wrt, if i remember correctly, there was a stp button on the basic config page. If this was checked, it would ignore the lan ip and manage to locate the wan ip.
Does anyone know if this is possible using the merlin firmware.
At present, i cannot use the ddns service.
Thank you.
Correction to the above, it is not the stp button. It is the below.
On my previous dd-wrt router which was also connected to the huawei router, i also received the ip address of 192.168.1.254 until i checked the radio button "do not use external ip check" on the ddns page.
Last edited: