mtakacs
New Around Here
Firmware: 3.0.0.4.354.28
I'm running a small business network in a warehouse with two RT-AC66U's running as Access Points.
Is there a way for me to see which AP's are serving which clients?
I'm looking for a less "syslog-ish" way to see this info from the Stations List entry of the syslog.
Advanced Settings | System Log | Wireless Log (tab)
Mode : AP Only
Stations List Rx/Tx speed rssi state
----------------------------------------------------------------------
10:xx:xx:xx:02:AC 450/121 Mbps -51 dBm assoc auth
10:xx:xx:xx:xx:XX 192.168.1.120 450/121 Mbps -54 dBm assoc auth
14:xx:xx:xx:B2:5D 192.168.1.168 450/121 Mbps -50 dBm
14:xx:xx:xx:04:BF 450/121 Mbps -53 dBm assoc auth
E0:xx:xx:xx:A3:24 192.168.1.177 364/121 Mbps -56 dBm assoc auth
auth
eg, here I can see that I've got three DHCP clients 1.120, 1.168 and 1.177, and two unknown mac-address only entries.
My other AP shows a different list.
I'd originally assumed Id find the info I wanted on the Network Map | Clients, but that shows the entire subnet (even my static/wired computers)
I'd be cool if the dump I had listed above were visible in the UI somewhere..
-Mark
I'm running a small business network in a warehouse with two RT-AC66U's running as Access Points.
Is there a way for me to see which AP's are serving which clients?
I'm looking for a less "syslog-ish" way to see this info from the Stations List entry of the syslog.
Advanced Settings | System Log | Wireless Log (tab)
Mode : AP Only
Stations List Rx/Tx speed rssi state
----------------------------------------------------------------------
10:xx:xx:xx:02:AC 450/121 Mbps -51 dBm assoc auth
10:xx:xx:xx:xx:XX 192.168.1.120 450/121 Mbps -54 dBm assoc auth
14:xx:xx:xx:B2:5D 192.168.1.168 450/121 Mbps -50 dBm
14:xx:xx:xx:04:BF 450/121 Mbps -53 dBm assoc auth
E0:xx:xx:xx:A3:24 192.168.1.177 364/121 Mbps -56 dBm assoc auth
auth
eg, here I can see that I've got three DHCP clients 1.120, 1.168 and 1.177, and two unknown mac-address only entries.
My other AP shows a different list.
I'd originally assumed Id find the info I wanted on the Network Map | Clients, but that shows the entire subnet (even my static/wired computers)
I'd be cool if the dump I had listed above were visible in the UI somewhere..
-Mark