VPN PPTP

[gimla]

Hello
I have a little problem with VPN PPTP client. I set everything username/pass, address of server and it is working fine. But if I restart router a can see VPN connection stats are ok, Routing Table is ok too, but internet (routing) and connection to VPN is not working. I have to disconnect from VPN, again connect and now it is working again.

Can someone help?

Thank you
Gimla

 

[john9527]

Hello
I have a little problem with VPN PPTP client. I set everything username/pass, address of server and it is working fine. But if I restart router a can see VPN connection stats are ok, Routing Table is ok too, but internet (routing) and connection to VPN is not working. I have to disconnect from VPN, again connect and now it is working again.

Can someone help?

Thank you
Gimla

On the WAN page, try setting the 'Redirect to error page' to Never.

 

[gimla]

It is not working

 

[john9527]

It is not working

What firmware level are you running?

 

[gimla]

Firmware is 378.51
It seems to me as if the tunnel was not properly created (Even though I can see the correct ip address, router table (traffict go through tunnel), stats about tunnel are fine) or will be created before the router is fully loaded.

If i change default route to my ISP so it is working, but i cannot reach site throught VPN tunnel (and I set up properly routes).

Is it possible to start VPN later? For example wait for 5 min.

 

[gimla]

Does anyone have a similar problem?