What's new

Review New In The Charts: NETGEAR RAX120

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Product Review

thiggins

Mr. Easy
Staff member
NETGEAR RAX120
NETGEAR's RAX120 Nighthawk 12-Stream Dual-Band WiFi 6 Router has been tested and added to SmallNetBuilder's Wi-Fi Router Charts. The sole Qualcomm-based Nighthawk in NETGEAR's RAX family sports four-streams on 2.4 GHz and eight on 5 GHz. But its 2.4 GHz performance lags behind the less-expensive RAX80 and is just about even on 5 GHz, making it not a great value. Check the Wi-Fi Router Charts for more details.

NETGEAR RAX120 vs. RAX80 2.4 GHz Rvr downlink
 
Another case of the spec's being better than the results.

Is this poorly written firmware or poorly executed hardware (or both)?
 
@thiggins
Did you test using the RAX120 v1 or v2? I believe the latter uses a slightly newer QCA chipset, possibily supporting OFDMA U/L.
 
This was v1. NETGEAR might send a v2 for retest. I don't think OFDMA is a factor in these results, since we're talking one STA per radio.

I should also note that the router could complete only 30 seconds of the wired routing test before it locked up and had to be rebooted. I tried this multiple times. NETGEAR has not been able to reproduce this yet.
 
Another case of the spec's being better than the results.

Is this poorly written firmware or poorly executed hardware (or both)?
I can't say. My tests don't provide data that would allow me to tell.
 
I should also note that the router could complete only 30 seconds of the wired routing test before it locked up and had to be rebooted. I tried this multiple times. NETGEAR has not been able to reproduce this yet.
Unless you have a bad Ethernet cable that's causing electrical noise on the switch port (highly unlikely in your lab environment, pretty sure you did swap cables), I'd bet it's a hardware issue with your unit rather than a design flaw.
 
Unless you have a bad Ethernet cable that's causing electrical noise on the switch port (highly unlikely in your lab environment, pretty sure you did swap cables), I'd bet it's a hardware issue with your unit rather than a design flaw.
What makes you say that?
 
What makes you say that?
If it was a general design flaw, crashing routers when doing something as basic as transferring data would most likely generate a lot of complains on online forums as it sounds like a very common scenario.
 
If it was a general design flaw, crashing routers when doing something as basic as transferring data would most likely generate a lot of complains on online forums as it sounds like a very common scenario.
Perhaps. Keep in mind the test uses 100 simultaneous connections each up and down, running TCP/IP full blast while pinging. It's pretty strenuous.

But I hear you. I'm continuing to investigate. The RAX80 has no problem with the test, nor do all the ASUS routers I've tested.
 
Perhaps. Keep in mind the test uses 100 simultaneous connections each up and down, running TCP/IP full blast while pinging. It's pretty strenuous.
Gotcha. That's indeed a quite unusual scenario.

I assume the router has no SSH access for you to monitor things while testing?
 

Latest threads

Support SNBForums w/ Amazon

If you'd like to support SNBForums, just use this link and buy anything on Amazon. Thanks!

Sign Up For SNBForums Daily Digest

Get an update of what's new every day delivered to your mailbox. Sign up here!

Staff online

Top