Zolt
Occasional Visitor
Hi there.
I had to do a reset on my home network - decided to restart fresh.
I have 2 identical RT-AC66U B1 router.
I had AiMesh setup before - I've set it up about 1.5 years ago - I can't remember which FW I had at the time, but it was an earlier version.
Now, no matter what I try, it doesn't seem to work.
The main router is working fine - it's all setup and working.
When I click on the Network Map > AiMesh Node > Search, I can seem my second router. When I select it and click Apply, I get this message:
Any suggestions?
Should I revert to an older firmware and try again, then upgrade to the newest firmware?
FYI, I also tried to go through the initial setup of the second router in hope I could then re-configure it as an AiMesh router, but it requires I do a reset and I'm back to square one.
Thanks for your help!
I had to do a reset on my home network - decided to restart fresh.
I have 2 identical RT-AC66U B1 router.
I had AiMesh setup before - I've set it up about 1.5 years ago - I can't remember which FW I had at the time, but it was an earlier version.
Now, no matter what I try, it doesn't seem to work.
The main router is working fine - it's all setup and working.
When I click on the Network Map > AiMesh Node > Search, I can seem my second router. When I select it and click Apply, I get this message:
Unable to add your AiMesh node RT-AC66U B1 (MAC-ADDRESS) to your AiMesh system due to the following situations. Please check and try again.
1. Someone else is trying to set up an AiMesh system. Please wait 1 minute and try again.
your AiMesh router and node should be within 3 meters of each other during the setup process.
2. Make sure your AiMesh node is powered on.
3. Your AiMesh node has been upgraded to AiMesh-supported firmware.
4. Your AiMesh node has been reset to default
Any suggestions?
Should I revert to an older firmware and try again, then upgrade to the newest firmware?
FYI, I also tried to go through the initial setup of the second router in hope I could then re-configure it as an AiMesh router, but it requires I do a reset and I'm back to square one.
Thanks for your help!