Upgrading my TS-251 Pro with latest FW ends in errors ...,

[Leguar]

Upgrading with the new TS-x53 20241025-5.2.1.2930 firmware ...

Hope for some help, upgrading my QNAS 253 Pro, from v. TS-x53 20240817-5.2.0.2860 to the new TS-x53 20241025-5.2.1.2930.

The upgrade ends with lots of beeps (nearly in any combinations). Have tried several times to do it over and over again. Even tried to go back to the former version, but because of warnings I didn't do that.

The problem arise, when kernel update is at 60%, then everything goes wrong, with lots of beeps.
Attached all the errors I can see.

I have another QNAP TS-251+ which upgraded without any problems.

Top

 

[degrub]

You may get a faster response over on the QNAP forums or tech support ticket.

 

[Leguar]

After 24+ hours I tried again to install the new FW.
This time without any problems, therefore I'm up
running again

But thinking back.... I have always problems with new FW's into my TS-253 Pro (80%),
where as my TS-251+ have no problems (1%) - (ok, one time it went wrong).