R7800 and 160mhz setup

[thegr8anand]

A simple question but tbh haven't found a simple answer to how to set it up properly.

1 - So once i enable HT160 in advanced settings i need to select a DFS channel to use a contiguous 160 and not 80+80?
2 - Do i need to disable Mu-Mimo when using HT160 mode?
3 - How do i test if its working as intended?

My setup is R7800 using Voxel V1.0.2.74.3SF firmware + Kamoj addon. Connecting with a netgear A7000 AC1900 usb wifi adapter.

Thanks.

 

[ulaganath]

A7000 doesn’t support ht160 mode it already have 3x3 antenna for total of 1300Mbps for 5ghz and 600Mbps for 2.4Ghz


Sent from my iPad using Tapatalk

 

[e38BimmerFN]

To Test, you need a client device that you know of that also supports 160Mhz. A connection rate of 1733Mbps will be see between the R7800 and any device that supports 160Mhz.
https://www.snbforums.com/threads/160mhz-in-bridge-mode-on-r7800.55335/

You should be able to leave MIMO enabled however this may not be needed as you will also need a MIMO supporting device to take advantage of MIMO.
Try a DFS channel and see. Also the connecting device needs to also support DFS channels. Some may not.

A simple question but tbh haven't found a simple answer to how to set it up properly.

1 - So once i enable HT160 in advanced settings i need to select a DFS channel to use a contiguous 160 and not 80+80?
2 - Do i need to disable Mu-Mimo when using HT160 mode?
3 - How do i test if its working as intended?

My setup is R7800 using Voxel V1.0.2.74.3SF firmware + Kamoj addon. Connecting with a netgear A7000 AC1900 usb wifi adapter.

Thanks.